Version 1.0 09/08/2017
http://www.inorea.com
27
5.
Chapter 5 Function parameter
5-1.Menu grouping
VFR-013 inverter function parameters are grouped by function, there is d0 group, F0 group to Fb
group, E0 group to E3 group, b0 group, y0 group to y1 group, L0 group, a total of 21 groups. Each
functional group includes several functional code.
F group and E group are the basic function parameters, d group is monitoring function
parameters and b group is motor parameters.
In order to more effectively carry out parameter protection, the inverter provides a password
protection of function code. y0.01 is used to set parameters protection password, you can enter into
parameter menu only after inputing correct password under function parameters mode. Password
protection is canceled when y0.01 is set to 00000.
L0 group is factory function parameters, users do not have access to the group of parameters.
Function parameter table "Change", change properties (ie, whether to allow the change or not
and change conditions) and symbol description is as follows:
"
★
": indicates that the parameter value can not be changed when the inverter is running;
"
●
": indicates that the parameter value is the actual measured value, can not be changed;
"
☆
": indicates that the parameter value can be changed when the inverter is running or stoped;
“
▲
”: "Factory parameters", prohibit the user to operate;
"-": indicates that the parameter factory default is none or the value is undefined.
Code
Parameter Group Name
Functional Description
Reference
page
d0 Monitoring function group
Monitoring frequency, current, etc
46
F0 Basic function group
Frequency setting, control mode, acceleration and
deceleration time
47
F1 Input terminals group
Analog and digital input functions
53
F2 Output terminals group
Analog and digital output functions
58
F3 Start and stop control group
Start and stop control parameters
61
F4 V/F control group
V/F control parameters
63
F5 Vector control group
Vector control parameters
65
F6 Keyboard and display group
To set key and display function parameters
67
F7 Auxiliary function group
To set Jog, jump frequency and other auxiliary function parameters
68
F8 Fault and protection group
To set fault and protection parameters
72
F9
Communication parameter
group
To set MODBUS communication function
74
FA Torque control group
To set parameters under torque control mode
76
Fb Control optimization group
To set parameters of optimizing the control performance
78
E0 Wobbulate control group
Wobbulate function parameters setting
79
