116
4.12.4
CLI Commands
Command Lines of the Warning configuration
Feature
Command Line
Relay Output
Relay Output
Switch(config)# relay 1
dry dry output
ping ping failure
port port link failure
ring ring failure
Dry Output
Switch(config)# relay 1 dry
<0-65535> turn on period in second
Switch(config)# relay 1 dry 5
<0-65535> turn off period in second
Switch(config)# relay 1 dry 5 5
Ping Failure
Switch(config)# relay 1 ping 192.168.10.33
<cr>
reset reset a device
Switch(config)# relay 1 ping 192.168.10.33 reset
<1-65535> reset time
Switch(config)# relay 1 ping 192.168.10.33 reset 60
<0-65535> hold time to retry
Switch(config)# relay 1 ping 192.168.10.33 reset 60 60
Port Link Failure
Switch(config)# relay 1 port
PORTLIST Port list, ex: fa1,fa3-5,gi17-20
Switch(config)# relay 1 port fa1-5
Ring Failure
Switch(config)# relay 1 ring
Disable Relay
Switch(config)# no relay
1 relay id
Switch(config)# no relay 1
Display
Switch# show relay 1
Relay 1
Event :
Power : Disabled
Port Link : Disabled
Ring : Disabled
Ping : Disabled
Ping Reset : Disabled
Dry Output : Disabled
DI : Disabled
Event Selection
Event Selection
Switch(config)# warning-event
coldstart Switch cold start event
warmstart Switch warm start event
authentication Authentication failure event
linkdown Switch link down event
linkup Switch link up event
ring Switch ring event
fault-relay Switch fault relay event
time-sync Switch time synchronize event
sfp Switch SFP event
loop-protect Switch loop protection event
Ex: Cold Start event
Switch(config)# warning-event coldstart
Set cold start event enable ok.
Ex: Link Up event
Switch(config)# warning-event linkup
[IFNAME] Interface name, ex: fastethernet1 or gi8
Summary of Contents for JetNet 6910G-M12 Series
Page 5: ...1 5 4 About Korenix 141...
