80
Leave Timer: Control the time to release the GVRP reservation after received the GVRP
Leave BPDU. An instance of the timer is required for each state machine that is in the LV
state
Leave All Timer: Controls the period to initiate the garbage collection of registered VLAN.
The timer is required on a per-Port, per-GARP Participant basis
4.6.4
VLAN Table
This table shows current settings of your VLAN table, including VLAN ID, Name, Status,
and Egress rule of the ports.
VLAN ID: ID of the VLAN.
Name: Name of the VLAN.
Status: Static shows this is a manually configured static VLAN. Unused means this VLAN
is created by UI/CLI and has no member ports. This VLAN is not workable yet. Dynamic
means this VLAN is learnt by GVRP.
After created the VLAN, the status of this VLAN will remain in Unused status until you add
ports to the VLAN.
4.6.5
CLI Commands of the VLAN
Command Lines of the VLAN port configuration, VLAN configuration and VLAN table
display
Feature
Command Line
VLAN Port Configuration
Port Interface
Configuration
Switch# con t
Switch(config)# interface fa5
Switch(config-if)#
VLAN Port PVID
Switch(config-if)# switchport trunk native vlan 2
Set port default vlan id to 2 success
QinQ Tunnel Mode
802.1Q Tunnel =
access
802.1Q Tunnel Uplink =
uplink
Switch(config-if)# switchport dot1q-tunnel
mode Set the interface as an IEEE 802.1Q tunnel mode
Switch(config-if)# switchport dot1q-tunnel mode
access Set the interface as an access port of IEEE
802.1Q tunnel mode
uplink Set the interface as an uplink port of IEEE
802.1Q tunnel mode
Port Accept Frame
Type
Switch(config)# inter fa1
Switch(config-if)# acceptable frame type all
Summary of Contents for JetNet 6910G-M12 Series
Page 5: ...1 5 4 About Korenix 141...
