Appendix C: Configuration or Firmware Upgrade with a USB Drive
672
Special configuration keys:
There are 3 special configuration keys that are prefixed with
magic:
.
A special key that sets a user account's password without
knowing the firmware's internal encryption/hashing algorithms
is implemented as of release 2.2.13.
Example:
magic:users[1].cleartext_password=joshua
Two special keys that set the SNMPv3 passphrases without
knowing the firmware's internal encryption/hashing algorithms
are implemented as of release 2.4.0.
Examples:
magic:users[1].snmp_v3.auth_phrase=swordfish
magic:users[1].snmp_v3.priv_phrase=opensesame
To configure device-specific settings:
1.
Make sure the device list configuration file "devices.csv" is available
in the PDU2. See
devices.csv
(on page 673)
2.
In the "config.txt" file, refer each device-specific configuration key to
a specific column in the "devices.csv" file. The syntax is:
${column}
,
where "column" is a column number.
Examples:
net.interfaces[eth0].ipv4.static.addr_cidr.addr=${4
}
pdu.name=${16}
Note: For firmware version 3.3.0 or older, the syntax for static ip
address is different from version 3.3.10 or later. It should be:
network.interfaces[eth0].ipaddr=${column}.
To rename the admin user:
As of release 3.1.0, you can rename the admin user by adding the
following configuration key:
users[0].name=new admin name
Example:
users[0].name=May
Summary of Contents for PX3-3000 series
