•
Hold-down timer: 9 through 65535 seconds.
•
Garbage-collection timer: 9 through 65535 seconds.
NOTE
You must enter a value for each timer, even if you want to retain the current setting of a particular timer.
To return to the default values of the RIPng timers, use the
no
form of this command.
Configuring route learning and advertising parameters
You can configure the following learning and advertising parameters:
•
Learning and advertising of RIPng default routes.
•
Advertising of IPv6 address summaries.
•
Metric of routes learned and advertised on a Brocade device interface.
Configuring default route learning and advertising
By default, the device does not learn IPv6 default routes (::/0). You can originate default routes into RIPng, which causes individual
Brocade device interfaces to include the default routes in their updates. When configuring the origination of the default routes, you can
also do the following:
•
Suppress all other routes from the updates.
•
Include all other routes in the updates.
For example, to originate default routes in RIPng and suppress all other routes in updates sent from Ethernet interface 1/3/1, enter the
following commands.
device(config)# interface ethernet 1/3/1
device(config-if-e100-1/3/1)# ipv6 rip default-information only
To originate IPv6 default routes and include all other routes in updates sent from Ethernet interface 1/3/1, enter the following
commands.
device(config)# interface ethernet 1/3/1
device(config-if-e100-1/3/1)# ipv6 rip default-information originate
Syntax:
[no] ipv6 rip default-information
{
only
|
originate
}
The
only
keyword originates the default routes and suppresses all other routes from the updates.
The
originate
keyword originates the default routes and includes all other routes in the updates.
To remove the explicit default routes from RIPng and suppress advertisement of these routes, use the
no
form of this command.
Advertising IPv6 address summaries
You can configure RIPng to advertise a summary of IPv6 addresses from a Brocade device interface and to specify an IPv6 prefix that
summarizes the routes.
If a route’s prefix length matches the value specified in the
ipv6 rip summary-address
command, RIPng advertises the prefix specified in
the
ipv6 rip summary-address
command instead of the original route.
Configuring RIPng
FastIron Ethernet Switch Layer 3 Routing
53-1003627-04
217
Summary of Contents for FastIron SX 1600
