X5368r-P3
User’s Manual Version 1.0
97
7.11
VoIP list endpoints
7.11.1 Syntax
voip list endpoints
7.11.2 Description
This command lists information about the endpoints which
have been added to the Voice-IAD
system using the
voip set endpoint ...
series of CLI
commands.
• To change the Endpoint name, use the command
voip
set endpoint epname
on page 93
.
• To change the Display name, use the command
voip set
endpoint displayname
on page 92.
• To change the Administration state use the command
voip set endpoint adminstate
on
page 89
.
• To change the codecs used by the endpoint, use the
command
voip set endpoint codecs
on
page 90.
• To change the password used by the endpoint, use the
command
voip set endpoint password
on page 94.
7.11.3 Example
X5368r-P3
User’s Manual Version 1.0
98
7.12
VoIP set endpoint adminstate
7.12.1 Syntax
voip set endpoint <index> adminstate <inservice | oos>
7.12.2 Description
This command can be used to take an endpoint
out-of-service (
oos
) or in-service (
inservice
).
Setting an MGCP endpoint in-service (when it is oos or
already in-service) sends a reset (RSIP) to
the MGCP Call Agent which re-initialises the line. This can
sometimes be an effective way to restore
the operation of the MGCP Call Agent.
Setting a SIP endpoint in-service (when it is oos or
already in-service) causes the Voice-IAD system
to re-register with the SIP Proxy Server.
7.12.3 Options
The following table gives the range of values for each
option which can be specified with this
command and a default value (if applicable):
Table 10-7: voip set endpoint adminstate CLI command
7.12.4 Example
prompt> voip set endpoint 1 adminstate inservice
