X5368r-P3
User’s Manual Version 1.0
103
7.16
VoIP set endpoint password
7.16.1 Syntax
voip set endpoint <index> password <password>
7.16.2 Description
This command sets a password to be associated with an
endpoint. This is the password a user must
enter to make a phone call if authentication is being used.
Note that authentication is setup and controlled by the SIP
Proxy Server,
not
the SIP endpoints.
Setting a password from the endpoint will have no effect
unless authentication is also set up on the
SIP Proxy Server.
This command is appropriate for SIP configuration only.
There is no endpoint password setting
functionality supported for MGCP.
7.16.3 Options
The following table gives the range of values for each
option which can be specified with this
command and a default value (if applicable):
Table 10-11:voip set endpoint password CLI command
7.16.4 Example
prompt>
voip set endpoint 1 password mypassword
X5368r-P3
User’s Manual Version 1.0
104
7.17
VoIP set interfacename
7.17.1 Syntax
voip set interfacename <name>
7.17.2 Description
This command is used to set the interface name that will
be used by the Voice-IAD system to find
the MGCP call agent or SIP Proxy Server. This interface
must be created using the
ip add interface
command. If the IP interface is not created, the SIP /
MGCP software will not start.
7.17.3 Options
The following table gives the range of values for each
option which can be specified with this
command and a default value (if applicable):
Table 10-12:voip set interfacename CLI command
7.17.4 Example
prompt>
voip set interfacename ipwan
