MAGNET POWER SUPPLY SYSTEM 7000
20
DANFYSIK A/S - DK 4040 JYLLINGE - DENMARK.
3.8
SW Commands
Following are the commands for the standard software listed in alphabetic order.
Please see the
ApBCPsw1a.doc Software command
for detail explanation on every command.
This issue is valid for software version BCP100
STANDARD COMMANDS. summary
X is a number from 0 to 9 and Commands in quotation marks are optional
AD X
Read value from an ADC
channel.
ADR
Read the address of the MPS.
ADR XXX
Write an address to a MPS.
ADCTRIG
Read the AD channel trig setup
CMD
Read current control mode.
CMDSTATE
Read current control state.
DA 0,XXXXXX Writes a value to an Digital to
Analog converter for setting the
output current. (Alternative to
the WA command.)
ERRC
Coded error message.
ERRT
Text string error message.
F Main
Power
OFF
LALL Listen
ALL.
LOC
Change to Local Control
LOCK
Lock the MPS in Local Control.
N Main
Power
ON
NERR
No error message
PO Polarity
status
PO +/-
Change to Normal polarity
PRINT
Reads internal user information
about the MPS.
RA
Read the set value.
REM
Change to remote control.
RLOCK Remote
line
only
RS Reset
interlocks.
S1
Read the internal status.
S1H
Read internal status in HEX
format
STB
Standby (Main Power ON
with clamped output in
ON/OFF/STB mode 2)
TD Test
DAC
TYPE
AD type in use
UNLOCK
Unlock the MPS
VER
Reads the software version
WA XXXXXX Writes a value to an Digital to
Analog converter for setting the
output current. (preferred
command DA 0,XXXXXX.)
