© 2003 - 2005 Sipura Technology, Inc
Proprietary (See Copyright Notice on Page 2)
81
CPC Delay
3,4
Delay in seconds after caller hangs up when
the SPA will start removing the tip-and-ring
voltage to the attached equipment of the called
party.
Range= 0 to 255(s)
Resolution = 1 (s)
2
CPC Duration
3,4
Duration in seconds for which the tip-to-ring
voltage is removed after the caller hangs up.
After that tip-to-ring voltage is restored and dial
tone will apply if the attached equipment is still
off hook. CPC is disabled if this value is set to
0.
Range= 0 to 1.000 (s)
Resolution = 0.001 (s)
0
(CPC
disable
d)
Notes:
1. The Call Progress Tones and DTMF playback level are not affected by the <FXS Port Output
Gain>.
2. The interdigit timer values are used as defaults when dialing. The Interdigit_Long_Timer is used
after any one digit, if all valid matching sequences in the dial plan are incomplete as dialed. The
Interdigit_Short_Timer is used after any one digit, if at least one matching sequence is complete
as dialed, but more dialed digits would match other as yet incomplete sequences.
3. SPA has had polarity reversal feature since release 1.0 which can be applied to both the caller
and the callee end. This feature is generally used for answer supervision on the caller side to
signal to the attached equipment when the call has been connected (remote end has answered)
or disconnected (remote end has hung up). This feature should be disabled for the called party (ie
by using the same polarity for connected and idle state) and the CPC feature should be used
instead.
4. Without CPC enabled, reorder tone will is played after a configurable delay. If CPC is enabled,
dial tone will be played when tip-to-ring voltage is restored.
3.5.9.4. Vertical
Service Code Assignment
Parameter Name
Description
Type
Default
Call Return Code
Call the last caller.
ActCode
*69
Blind Transfer Code
Blind transfer current call to the target
specified after the activation code
ActCode *98
Cfwd All Act Code
Forward all calls to the target specified
after the activation code
ActCode *72
Cfwd All Deact Code
Cancel call forward all
ActCode
*73
Cfwd Busy Act Code
Forward busy calls to the target specified
after the activation code
ActCode *90
Cfwd Busy Deact Code
Cancel call forward busy
ActCode
*91
Cfwd No Ans Act Code
Forward no-answer calls to the target
specified after the activation code
ActCode *92
Cfwd No Ans Deact Code
Cancel call forward no-answer
ActCode
*93
Cfwd Last Act Code
Forward the last inbound or outbound calls
to the target specified after the activation
code
ActCode *63
Cfwd Last Deact Code
Cancel call forward last
ActCode
*83
Block Last Act Code
Block the last inbound call
ActCode
*60
Block Last Deact Code
Cancel blocking of the last inbound call
ActCode
*80
Accept Last Act Code
Accept the last outbound call. Let it ring
through when DND or Call Forward All is in
ActCode *64
