FXSO H.323 Gateway User Manual
Document Ver.: 105
Release Dec, 2004
95
-ip
create routing table for incoming call from IP side. (route –ip
dst “destination port type” e164 “e.164 number of port”)
-FXSO
create routing table for incoming call fromFXSO Lines.
(
route –FXSO dst “destination port type” e164 “e.164
number of port”
)
prefix
prefix of dialed number
dst
destination port, 1 meansFXSO Lines, 2 means IP side, x
means no determinate number.
e164
destination e.164 number. This only need to be set when
routed port is FXS TELs orFXSO Lines to determine which
port will this call be routed to.
min
minimum digits needed.
max
maximum digits needed.
hunt
set hunt method for busy forward. 0 means no hunting, 1
means hunting method follows the rule of [line], 2 means
hunting method is to hunt between all ports in the same type.
Usage Example:
1. route –add prefix 100 dst 1 e164 1001 min 1 max 3 hunt 1
This command means if gateway has incoming call’s prefix number is
100, and total digits is between 1 to 3, this call will be routed to FXS
TEL 1001, and if TEL 1001 is busy, call will be routed to another FXS
TEL.
2. route –FXSO dst 1
This command means incoming call fromFXSO Lines will be routed
toFXSO side.
Note:
(1) If user doesn’t want to determine a specific port to route, e.164
number must set as “x” and the call will be routed to the first port.
(Ex. route – ip dst 1 e164 x)
(2) Default value: Incoming call from FXS andFXSO ports will be
forward to IP side.
4.2.19 [tone]
This command is basically forFXSO ports.
-------------------------------------------------------------------------------------------------
