F4000N Series Operating Manual
Section 3: Teaching Overview
Part # 562187N-1
Rev. D Sep 2012
18
© 2012 Fisnar Inc.
3.
Point Type & Function Summary
3.1
Point Menu (F1)
Below is a list of Point Types, which are found under the
F1
key (
Point
menu):
Function
Description
Dispense Dot
Registers the current XYZ location as a Dispense point for dot
dispensing.
Line Start
Registers the current XYZ location as a Line Start point for line
dispensing.
Line Passing
Registers the current XYZ location as a Line Passing point. This is a
location on the line where the tip changes direction, such as at the
corner on a rectangle.
Circle
Registers a circle with the circle center at the current XYZ location. The
display will prompt the user for the circle diameter.
Arc Point
Registers the current XYZ location as an Arc point. Arc points are used
to dispense material in an arc or circle.
Line End
Registers the current XYZ location as a Line End point.
End Program
Registers the current memory address as the end of the program.
Dispense On /
Off
Registers an instruction which turns the dispenser on or off at the
current XYZ location.
GOTO
Address
Causes the program to jump to the specified memory address.
Step & Repeat
Registers an instruction that will re-run a selected group of memory
addresses, stepping by a user-defined distance in the X or Y-axis after
each copy. The matrix of parts is defined by specifying the number of
rows, the number of columns, the X offset and the Y offset.
Step & Repeat
X
indicates that the robot will give priority to the X-axis,
running the parts along the X-axis first.
Step & Repeat
Y
indicates that the robot will give priority to the Y-axis,
running the parts along the Y-axis first.
Brush Area
Causes the tip to „paint‟ the defined area. The painted area can be in
the form of a rectangle or a circle / spiral.
Call
Subroutine
Causes the machine to jump to a specified memory address and
execute the instructions found there. When the end program instruction
is reached, program execution will continue at address just after the call
Subroutine instruction.
Summary of Contents for F400N Series
Page 118: ......
