Nvis 5586A
Nvis Technologies Pvt. Ltd.
59
I – Interrupt:
Three Interrupts (Effective address) can be set in for the program execution; the CPU will
continuously make a single-step subprogram for checking IP values. When the IP register
has the same value as the Interrupt‘s address, it will enter the Interrupt‘s subprogram. Enter
command ―I‖ will interrupt the program.
Syntax:
The I key allows interruption to be shown on the screen.
Note:
1.
During interrupt setting, the address alternation register has commands like POP ES,
MOV DS, AS, etc. to execute with the next command.
2.
The program will be delayed for due to the fact that CPU has to send each command
individually into the subprogram.
3.
During the interruption, the commands GO would allow the program to execute until
the next INTERRUPT.
Example:
To break point at 0402, 0407 and 0411 in the example given on Page-3, the following steps
are to be taken:
1.
Press the key F7 and the LCD display is as shown here:
Summary of Contents for 5586A
Page 2: ...Nvis 5586A Nvis Technologies Pvt Ltd 2...
Page 23: ...Nvis 5586A Nvis Technologies Pvt Ltd 23 Memory Read Timing in Maximum Mode...
Page 30: ...Nvis 5586A Nvis Technologies Pvt Ltd 30...
Page 48: ...Nvis 5586A Nvis Technologies Pvt Ltd 48 Diagram of module RESET power Instruction Set Note...
