3 – Virtual I/O Command Line Interface
Groups and Commands
3-72
D000025-002 Rev. A
S
ethExtCurrentSpeedGet
Display the speed/duplex mode currently in use by the specified Ethernet port.
Syntax:
Options:
NOTE:
Displays the current speed/duplex values in use by the specified external
Ethernet port. The port parameter can be either a single port, or a list of
ports separated by spaces and enclosed in double quotes.
ethExtLacpInfo
Show Lacp-related information on one or all external Ethernet ports.
Options:
Sample Output:
NOTE:
With no parameters, this command displays an overview of Lacp information
for all external Ethernet ports The table contains the following information:
Port
: The external Ethernet port that this line refers to. Link: Link
status for the port (i.e. up or down).
Lacp
: Indicates whether 802.3ad is enabled or disabled.
Agg#
: 802.3ad or manual aggregation index.
State
: Indicates success/failure of 802.3ad to put port into an
aggregation
Failover
: Minimum number of ports for failover to run (if link
down).
Key
: 802.3ad actor key for the port.
ID
: 802.3ad actor system Id for the port.
PartnerPort
: 802.3ad partner port number.
ethExtCurrentSpeedGet <port> or ethExtCurrentSpeedGet
"<port1> <port2> ..."
port
External Ethernet port to read the speed/duplex mode currently in use.
port
Optional port number.
ethExtLacpInfo [port]
