2 – Switch Command Line Interface
Groups and Commands
D000025-002 Rev. A
2-25
A
uiConfig
View or configure the user interfaces to this device.
Syntax:
Options:
Sample Output:
NOTES:
There are several access methods for this device. With no arguments,
this command displays which access methods are available, and whether each
method is enabled or disabled.
This command can also be used to enable or disable various access methods. Use
'-<proto> 0' to disable a protocol, and '-<proto> 1' to enable. Multiple operations
may be specified in a single command.
A reboot is not required for this command. Depending on the specific method, it
may take 5-10 seconds for the changes. Note that existing connections (for example
a telnet session) will not be affected by disabling the underlying access method.
Any access method supported by the device (but not listed here) cannot be
configured and is always enabled.
uiConfig [-telnet 0|1] [-https 0|1] [-http 0|1] [-ftp
0|1] [-snmp 0|1]
[telnet]
Enable/disable access to the device via telnet..
[https]
Enable or disable https access.
[http]
Enable or disable http access.
[ftp]
Enable or disable ftp access.
[snmp]
Enable or disable SNMP access.
-> uiconfig -telnet 0
Successfully modified configuration.
Option Value
-----------------------
telnet 0
http 1
https 0
ftp 1
snmp 1
