2 – Switch Command Line Interface
Groups and Commands
2-88
D000025-002 Rev. A
S
Sample Output:
NOTES:
This command works only on platforms supporting 12X link aggregation
(currently the 9024 and 9080).
This command will enable 12X link aggregation so that internal and external
switching will be 12x. Each 12X port is 3 aggregated 4x ports (i.e., a TRIO), where
one will be reported as a 12x port, and the other two ports are reported as disabled.
Each of the three aggregated 4x ports must be connected to another enabled 12X
TRIO to establish a 12X link. Using this command without the option enable12xBit
displays the ports current values. The device must be rebooted to activate changes
made with this command.
Calling this command without the enable12xBit will display the current values of the
port(s).
ismChassisSetSpeed
Allows the user to view and set port link speeds (including external ports) for the entire chassis to 2.5
(SDR), 5.0 (DDR) or AutoNegotiate.
Syntax:
Options:
Sample Output:
-> ismChassisSet12x
L01P01 12x mode is DISABLED
L01P02 12x mode is DISABLED
L01P03 12x mode is DISABLED
L01P04 12x mode is DISABLED
L01P05 12x mode is DISABLED
L01P06 12x mode is DISABLED
L01P07 12x mode is DISABLED
L01P08 12x mode is DISABLED
L01P09 12x mode is DISABLED
L01P10 12x mode is DISABLED
L01P11 12x mode is DISABLED
ismChassisSetSpeed [speed]
speed
1=2.5, 2=5.0 or 3=AutoNegotiate.
-> ismChassisSetSpeed
L01P01 link speed is AUTO NEGOTIATE
L01P02 link speed is AUTO NEGOTIATE
L01P03 link speed is AUTO NEGOTIATE
L01P04 link speed is AUTO NEGOTIATE
L01P05 link speed is AUTO NEGOTIATE
L01P06 link speed is AUTO NEGOTIATE
L01P07 link speed is AUTO NEGOTIATE
L01P08 link speed is AUTO NEGOTIATE
