3 – Virtual I/O Command Line Interface
Groups and Commands
D000025-002 Rev. A
3-73
A
PartnerKey
: 802.3ad partner key.
PartnerID
: 802.3ad partner system Id.
For a manually configured aggregation, the following columns
are displayed:
Port
: The external Ethernet port that this line refers to.
Link
: Link status for the port (i.e. up or down)
Agg#
: Aggregation the port currently belongs to
Manual Agg #
: Requested manual aggregation index
Failover
: Minimum number of ports for failover to run (if link is
down).
This command can optionally take an external Ethernet port
number as it is the only arguement. In this case, the output will
be detailed information about the link aggregation status and
configuration for the specified port.
ethExtLacpEnable
Enables 802.3ad for the specified Ethernet port.
Syntax:
Options:
Sample Output:
NOTE:
Enables 802.3ad Lacp for the specified ports. If any of the ports are part of
a manual aggregation, they will first be removed from the aggregation. The
port parameter can be either a single port, or a list of ports separated by
spaces and enclosed in double quotes.
Usage: ethExtLacpEnable <port> or ethExtLacpEnable
"<port1> <port2> ..."
port
External Ethernet port (or list of ports) to enable Lacp.
-> ethExtLacpEnable 1
802.3ad Lacp enabled for External Ethernet port 1 [Ext-1].
