-211 Trigger ignored
A Group Execute Trigger (GET) or *TRG was received but the trigger
was ignored.
-213 Trigger deadlock
A trigger deadlock occurs when the trigger source is BUS and a READ?
Command is received
-214 Init Ignored
An INITiate command was received but could not be executed because
a measurement was already in progress. Send a device clear to halt a
measurement in progress and place the meter in the “idle” state.
-221 Settings conflict
This error can be generated in one of the following situations:
Situation 1:
You sent a CONFigure or MEASure command with
autorange enabled and with a fixed resolution.
Situation 2:
You turned math on and then changed to a math
operation that was not valid with the present measurement function.
-222 Data out of range
A numeric parameter value is out of range.
-223 Too much data
A character string was too long.
-224 Illegal parameter value
A discrete parameter was received which was not a valid choice for the
command.
141
