iSXblue/SXBlue II GNSS Series Technical Reference Manual
100
Data Field
Description
freq
Frequency (MHz) of the spot beam
long
Longitude of the center of the spot beam (in degrees)
lat
Latitude of the center of the spot beam (in degrees)
baud
Baud rate at which this spot beam is modulated
satlong
Satellites longitude (in degrees)
Example:
$>JLBEAM,Sent 1557.8450,Used 1557.8450,Baud 1200,Geo 0
$>JLBEAM,1535.1250,-26,40,600,(9999)
$>JLBEAM,1535.1575,65,30,600,(9999)
$>JLBEAM,1535.1850,136,-25,1200,(160)
$>JLBEAM,1535.1850,172,-40,1200,(160)
$>JLBEAM,1557.8350,-100,50,1200,(9999)
$>JLBEAM,1557.8350,-101,66,1200,(9999)
$>JLBEAM,1557.8450,-74,52,1200,(9999)
$>JLBEAM,1557.8550,-122,45,1200,(9999)
$>JLBEAM,1535.1375,-85,2,1200,(-98)
$>JLBEAM,1535.1375,-60,-25,1200,(-98)
$>JLBEAM,1535.1375,-142,15,1200,(-98)
$>JLBEAM,1535.1375,109,2,1200,(109)
$>JLBEAM,1535.1375,140,38,1200,(109)
$>JLBEAM,1537.4400,23,-2,1200,(25)
$>JLBEAM,1537.4400,14,59,1200,(25)
$>JLBEAM,1537.4400,11,28,1200,(25)
5.5.2
$JLXBEAM
This command displays the current spot beams used by the OmniSTAR built-in engine. This command
has the following layout:
$JLBEAM<CR><LF>
Response:
$>JLBEAMEX,0 (1)
$> Table:0 (2)
$> Beam:1,DDSfreq1,long1,lat1,symbol1,satlong1
$> Beam:n,DDSfreqn,longn,symboln,satlongn
$> Table:1
The response components are described in the following table:
Data Field
Description
DDSfreq
DDS Frequency
long
Longitude of the spot beam centroid (in degrees)
lat
Latitude of the spot beam centroid (in degrees)
symbol
Symbol rate used for that particular spot beam
satlong
Satellites longitude (in degrees)
Example:
