Remote Commands for Analog Demodulation Measurements
R&S
®
FSW-K7
354
User Manual 1173.9240.02 ─ 23
Suffix:
<n>
.
<m>
Parameters:
<State>
ON | OFF | 1 | 0
*RST:
0
Example:
CALC:MARK2:FUNC:PNO ON
Switches on the phase-noise measurement for the marker 2.
Manual operation:
See
"Phase Noise Measurement State"
See
"Switching All Phase Noise Measurements Off"
CALCulate<n>:MARKer<m>:FUNCtion:PNOise:RESult?
This command queries the result of a phase noise measurement in the Analog Demod-
ulation application.
If necessary, the command activates the measurement first.
Suffix:
<n>
.
<m>
Return values:
<PhaseNoise>
numeric value
The difference between the measured carrier power and the
noise power at the position of the specified (normal) marker.
Example:
CALC:MARK2:FUNC:PNO:RES?
Outputs the result of phase-noise measurement of the marker 2.
Usage:
Query only
Manual operation:
See
"Phase Noise Measurement State"
11.8.2 Defining Limit Checks
Note that in remote control, upper and lower limit lines are configured using separate
commands. Thus, you must decide in advance which you want to configure. The x-val-
ues for both upper and lower limit lines are defined as a common control line. This con-
trol line is the reference for the y-values for both upper and lower limit lines.
..........................................................................................355
............................................................................................ 364
Checking the Results of a Limit Check
................................................................. 366
Programming Example: Using Limit Lines
............................................................ 367
Analyzing Results
