...the world's most energy friendly microcontrollers
2014-07-02 - Gecko Family - d0001_Rev1.30
486
www.silabs.com
Changed formula in VDDLEVEL bitfield in ACMPn_INPUTSEL.
Added sine wave minimum amplitude to BUFEXTCLK.
Changed description of IRQERASEABORT.
Updated description of WARMUPMODE in ADC section.
Fixed description for REFSEL field in CMU_CALCTRL.
Fixed description of RXDATAV and TXBL interrupt flags in CMU.
Added documentation for DMA_CHREQSTATUS, DMA_CHSREQSTATUS.
Renamed DMA_WAITSTATUS to DMA_CHWAITSTATUS and updated bit fields.
Fixed description of ACMP pin output, the GPIO pin must also be set as output.
Removed reference to the DAC LPF and LPFFREQ and LPFEN bitfields in DACn_CTRL.
Added revision C to Table 3.3 (p. 10) .
Changed REFSEL to UPSEL in Figure 11.6 (p. 102) .
Added information to the USART chapter that TXTRI is read as 0 if AUTOTRI is set.
Updated general description of bus system.
Updated frequency limitations when clocking TIMER from external source.
Updated information on disabling of individual LCD segment lines.
30.4 Revision 1.00
September 6th, 2010
Changed PCNT_TOP reset value.
Parity bits not available for USART synchronous mode.
Corrected Scaled VDD equation in Section 23.3.4 (p. 357) .
DACOUT0 and DACOUT1 in ADCn_SINGLECTRL renamed to DAC0OUT0 and DAC0OUT1.
CH4 in ADCn_SINGLECTRL under DIFF = 1 renamed to DIFF0.
Changed note about minimum acquisition time when sampling V
dd
/3 in Section 25.3.4 (p. 377) .
Added information about new individual LCD pin disable feature.
Switched LPFMODE DECAP and RCFILT in ADCn_CTRL register description.
Added EBI Regions and Peripheral Bit Band Alias to System Address Space in Figure 5.2 (p. 16) .
Changed VCMP_INPUTCTRL to VCMP_INPUTSEL in Section 24.3.4 (p. 367) , it now complies with
register description.
Corrected conversion time numbers in Section 25.3.2 (p. 375) .
Changed ENERGYMODE to WARMUPMODE in Section 25.3.3 (p. 376) .
Summary of Contents for EFM32G
Page 505: ......