Event and Performance Logging
119
Horizon Compact Plus Release 1.0.1
Wireless Ethernet Product User Manual
– Volume 2
Required Action
Steps
save log
Saves the events log to a specified ftp server.
Sequence :
save log ftp:[mylogfile]
press Enter
Note: The maximum system log file size for ftp to a server holds
about 1200 events (100KB). If more than 1200 events are stored
on the system, then multiple files will be created and named as
"mylogfile1", "mylogfile2" etc.
The system responds (example):
Enter the IP address of FTP server followed by 'Enter' Key :[ip
address]
220 ProFTPD 1.2.5 Server (Dragonwave FTP Site)
[support.dragonwaveinc.com]
UserName :username
331 Password required for username.
Password :*******
230 User username logged in.
Copy log entries to a file? Enter Y(yes) or N (no):y
Trying to copy the data to mylogfile File. Please wait for a while.
200 PORT command successful.
150 Opening ASCII mode data connection for mylogfile.
226 Transfer complete.
Data successfully transferred to specified file. 221 Goodbye.
erase log
Removes all entries from the events log
Sequence :
erase log
press Enter
The system responds :
Erased log succcessfully.
18.2 Performance Log
Issuing the CLI command
set performance logging [on/off]
enables or disables the Performance Log.
This log collects system performance information at time intervals that are configured using the CLI
command
set performance log interval [hh:mm:ss].
See Procedure 18-2 for more details.
Between 6000 and 8000 entries can be logged before the Performance Log memory is full. Once the
memory is full, new entries will overwrite the oldest entries. The following table assumes that an
average of 7000 entries will occur before memory overflow. If the memory accepts more entries, then
the log duration before overflow will be extended.
