Model 2651A High Power System SourceMeter® Instrument Reference Manual
Section 6: Instrument programming
2651A-901-01 Rev. A / March 2011
6-11
To save a script to nonvolatile memory:
1. Create and load a named script (see
(on page 6-3)).
2. Do one of the following:
•
Send the command
scriptVar
.save()
, where
scriptVar
is the name of the script.
•
In TSB Embedded, click
Save Script
.
Example: Save a user script to nonvolatile memory
test1.save()
Assume a script named "test1"
has been loaded.
test1
is
saved into nonvolatile memory.
To save a script to an external USB drive:
NOTE
When you save a script to a USB flash drive, you do not need to specify a file extension;
.tsp
is
automatically added. If you do specify a file extension, it must be
.tsp
; an error will occur if you use
any other file extension.
1. Load a script (see
2. Send the command:
scriptVar
.save("/usb1/
filename
.tsp")
, where:
scriptVar
is the
variable referencing the script and
filename
.tsp
is a name of the file.
NOTE
You can also use TSB Embedded to save a script to a USB flash drive (or any accessible drive)
installed on your computer. From TSB Embedded, load the script and click
Export to PC
.
Delete user scripts
NOTE
These steps remove a script from nonvolatile memory. To completely remove a script from the
system, there are additional steps you must take. See
Delete user scripts from the instrument
(on
You can delete the script from nonvolatile memory by sending either of the following commands:
•
script.delete("
name
")
•
script.user.delete("
name
")
Where:
name
is the user-defined name of the script.
If you are using TSB Embedded, to delete a script from nonvolatile memory:
1. In TSB Embedded, select the script from the User Scripts list.
2. Click
Delete
. There is no confirmation message.
