Command Line Interface Reference for the ProSafe 7200 Series Layer-2 Switches, Software Ver-
Quality of Service (QoS) Commands
14-11
v1.0, February 2007
14.3.2 class-map rename
This command changes the name of a DiffServ class. The
<class-map-name>
is the
name of an existing DiffServ class. The
<new-class-map-name>
parameter is a case-
sensitive alphanumeric string from 1 to 31 characters uniquely identifying the class (The
<class-map-name>
‘default’ is reserved and must not be used here).
Format
class-map rename <class-map-name> <new-class-map-
name>
Mode
Global Config
14.3.3 match ethertype
This command adds to the specified class definition a match condition based on the value
of the ethertype. The
<ethertype>
value is specified as one of the following keywords:
appletalk
,
arp
,
ibmsna
,
ipv4
,
ipv6
,
ipx
,
mplsmcast
,
mplsucast
,
netbios
,
novell
,
pppoe
,
rarp
or as a custom ethertype value in the range of 0x0600-0xFFFF.
Format
match ethertype
{<
keyword
> |
custom
<0x0600-
0xFFFF>}
Mode
Class-Map Config
14.3.4 match any
This command adds to the specified class definition a match condition whereby all packets
are considered to belong to the class.
Format
match any
Mode
Class-Map Config
14.3.5 match class-map
This command adds to the specified class definition the set of match conditions defined
for another class. The
<refclassname>
is the name of an existing DiffServ class whose
match conditions are being referenced by the specified class definition.
Format
match class-map <refclassname>
Mode
Class-Map Config
The following ruules apply to this command:
•
The parameters
<refclassname>
and
<class-map-name>
can not be the same.
•
Only one other class may be referenced by a class.
Summary of Contents for GSM7224 - Switch
Page 4: ...v1 0 February 2007 iv...
Page 20: ...xx v1 0 February 2007...
