Programming Guide
24
CARR, FRQ
<frequency>
Value of carrier frequency.
CARR, AMP
<amplitude>
Value of carrier amplitude.
CARR, OFST
<offset>
Value of carrier offset.
CARR, SYM
<symmetry>
Value of carrier symmetry. Only ramp can set
this parameter.
CARR, DUTY
<duty>
Value of duty cycle. Only square and pulse
can set this parameter.
CARR, PHSE
<phase>
Value of carrier phase.
CARR, RISE
<rise>
Value of rise time. Only Pulse can set this
parameter.
CARR, FALL
<fall>
Value of fall time. Only Pulse can set this
parameter.
CARR, DLY
<delay>
Value of carrier delay. Only PULSE can set
this parameter.
Note: If c
arrier wave is Noise you can’t set to turn on modulation.
If you want to set AM, FM, PM, CARR and STATE the first parameter have to be one of them.
where:
<state>:={ON, OFF}
<src>:= {INT, EXT}
<mod wave shape>:={SINE, SQUARE, TRIANGLE, UP RAMP, DNRAMP,
NOISE, ARB}
<am frequency>:= {Default unit is "Hz". Value depends on the model.}
<depth>:= {0% to 120%}
<fm frequency>:= {Default unit is "Hz". Value depends on the model.}
<fm frequency deviation > :={ 0 to carrier frequency, Value depends on the
difference between carrier frequency and bandwidth frequency.}
<pm frequency> :={ Default unit is "Hz", Value depends on the model.}
<pm phase deviation >:= {0 to 360.}
<pwm frequency>:= {Default unit is "Hz", Value depends on the model. }
<pwm dev>:= { Default unit is "%",value depends on carrier duty cycle}
<ask key frequency>:= {Default unit is "Hz", Value depends on the model.}
<fsk frequency>:= { Default unit is "Hz", Value depends on the version.}
<fsk jump frequency>:= { the same with basic wave frequency}
<wave type>:={SINE ,SQUARE, RAMP, ARB, PULSE }
<frequency> :={ Default unit is "Hz", Value depends on the model.}
<amplitude> :={ Default unit is "V", Value depends on the model.}
<offset> :={ Default unit is "V", Value depends on the model.}
<duty>:= {0% to 100 %.}
<symmetry>:={ 0% to 100%}
<rise>:= {Value depends on the model.}
<fall>:= {Value depends on the model.}
<delay>:= {Default unit is "S".}
Summary of Contents for SDG5000 series
