Programming Guide
29
EDGE
<edge>
Value of edge. When carrier is NOISE wave, you
can’t set it. When NCYC is chosen and TRSR is set
to EXT, you can set it.
TIME
<circle time>
Value of Ncycle number. When carrier is NOISE
wave, you can’t set it. When NCYC is chosen you
can set it.
MTRIG
<manual trig>
Manual trigger. When TRSR is set to MAN, it can be
set.
CARR,
WVTP
<wave type>
Value of carrier type.
CARR, FRQ
<frequency>
Value of carrier frequency
CARR, AMP
<amplitude>
Value of carrier amplitude.
CARR, OFST
<offset>
Value of carrier offset.
CARR, SYM
<symmetry>
Value of symmetry. Only Ramp can set this
parameter.
CARR,
DUTY
<duty>
Value of duty cycle. Only Square or Pulse can set
this parameter.
CARR,
PHSE
<phase>
Value of carrier phase.
CARR, RISE
<rise>
Value of rise edge. Only when carrier is Pulse, the
Value is valid.
CARR, FALL
<fall>
Value of fall edge. Only when carrier is Pulse, the
Value is valid.
CARR,
STDEV
<standard
deviation >
Value of standard deviation. Only when carrier is
Noise, the Value is valid.
CARR,
MEAN
<mean>
Value of mean. Only when carrier wave is Noise, the
Value is valid.
CARR, DLY
<delay>
Value of delay. Only when carrier is Pulse, the
parameter is valid
Note: If you want to set CARR and STATE, the first parameter has to one of them
where:
<state>:= {ON, OFF}
<period>:= {Default unit is
“S”. Value depends on the model.}
<start phase>:= {0 to 360}
<gate ncycle>:= {GATE, NCYC}
<trigger source>:= {EXT, INT, MAN}
<delay>:= {Default unit is "S", Value depends on the model.}
<polarity>:= {NEG, POS}
<trig mode >:= {RISE, FALL, OFF}
<edge>:= { RISE, FALL}
<circle time> :={ Value depends on the Model (
“INF” means
infinite).}
Summary of Contents for SDG5000 series
