DXS-3326GSR Stackable Gigabit Layer 3 Switch
config sim
Description
This command is used to configure parameters of switches of the
SIM.
Parameters
commander
– Use this parameter to configure the commander
switch for the following parameters:
candidate
– Used to change the role of a commander switch to a
candidate switch.
Restrictions
group_name <groupname 64>
- Used to update the name
of the group. Enter an alphanumeric string of up to 64
characters to rename the SIM group.
dp_interval
<30-90>
– The user may set the discovery
protocol interval, in seconds that the Switch will send out
discovery packets. Returning information to the commander
switch will include information about other switches
connected to it. (Ex. MS, CaS). The user may set the
discovery protocol interval from 30 to 90 seconds.
hold time <sec 100-255>
– Using this parameter, the user
may set the time, in seconds, the Switch will hold
information sent to it from other switches, utilizing the
discovery interval protocol. The user may set the hold time
from 100 to 255 seconds.
dp_interval
<30-90>
– The user may set the discovery
protocol interval, in seconds that the Switch will send out
discovery packets. Returning information to the commander
switch will include information about other switches
connected to it. (Ex. MS, CaS). The user may set the
dp_interval
from 30 to 90 seconds.
hold time <sec 100-255>
– Using this parameter, the user
may set the time, in seconds, the Switch will hold
information sent to it from other switches, utilizing the
discovery interval protocol. The user may set the hold time
from 100 to 255 seconds.
Only
administrator-level users can issue this command.
To change the time interval of the discovery protocol:
DXS-3326GSR:4#config sim commander dp_interval 30
Command:config sim commander dp_interval 30
Success.
DXS-3326GSR:4#
To change the hold time of the discovery protocol:
DXS-3326GSR:4# config sim commander hold_time 120
Command: config sim commander hold_time 120
251
