DXS-3326GSR Stackable Gigabit Layer 3 Switch
config vrrp vrid
disable
.
Restrictions Only
administrator-level users can issue this command.
Example usage:
To configure a VRRP entry:
DXS-3326GSR:4#config vrrp vrid 1 state enable priority
100 advertisement_interval 2
Command: config vrrp vrid 1 state enable priority 100
advertisement_interval 2
Success.
DXS-3326GSR:4#
config vrrp ipif
Purpose
To configure the authentication type for a VRRP entry.
Syntax
config vrrp ipif <ipif_name 12> [authtype [none | simple
authdata <string 8> | ip authdata <string 16>]
Description
This command is used to set the authentication type for a VRRP
entry on the Switch.
Parameters
ipif <ipif_name 12>
- Enter the name of a previously configured IP
interface that you wish to configure the VRRP entry for. This IP
interface must be assigned to a VLAN on the Switch.
authtype
– Specifies the type of authentication used. The authtype
must be consistent with all routers participating within the VRRP
group. The user may choose between:
Restrictions Only
administrator-level users can issue this command.
none
– Entering this parameter indicates that VRRP protocol
exchanges will not be authenticated.
simple authdata <string 8>
- This parameter, along with an
alphanumeric string of no more than eight characters, to set
a simple password for comparing VRRP message packets
received by a router. If the two passwords are not exactly
the same, the packet will be dropped.
ip authdata <string 16>
- This parameter will require the user
to set an alphanumeric authentication string of no more than
16 characters to generate a MD5 message digest for
authentication in comparing VRRP messages received by
the router. If the two values are inconsistent, the packet will
be dropped.
Example usage:
271
