DXS-3326GSR Stackable Gigabit Layer 3 Switch
config syslog host all
local4
−
Specifies that local use 4 messages will be sent to the
remote host. This corresponds to number 20 from the list above.
local5
−
Specifies that local use 5 messages will be sent to the
remote host. This corresponds to number 21 from the list above.
local6
−
Specifies that local use 6 messages will be sent to the
remote host. This corresponds to number 22 from the list above.
local7
−
Specifies that local use 7 messages will be sent to the
remote host. This corresponds to number 23 from the list above.
udp_port <int>
−
Specifies the UDP port number that the syslog
protocol will use to send messages to the remote host.
state [enable | disable]
−
Allows the sending of syslog messages
to the remote host, specified above, to be enabled and disabled.
Restrictions Only
administrator-level users can issue this command.
Example usage:
To configure all syslog hosts:
DXS-3326GSR:4#config syslog host all severity all facility local0
Command: config syslog host all severity all facility local0
Success.
DXS-3326GSR:4#
delete syslog host
Purpose
Used to remove a syslog host, that has been previously
configured, from the Switch.
Syntax
delete syslog host [<index 1-4> | all]
Description
The
delete syslog host
command is used to remove a syslog
host that has been previously configured from the Switch.
Parameters
<index 1-4>
−
Specifies that the command will be applied to an
index of hosts. There are four available indexes, numbered 1
through 4.
all
−
Specifies that all syslog hosts will be deleted.
Restrictions Only
administrator-level users can issue this command.
Example usage:
To delete a previously configured syslog host:
76
