For paper sizes other than A4 or letter, you must use commands from the
host computer that tell the printer the paper size you are using. These
commands tell the printer where to print on the page. An example of this
would be printing on legal-size paper. Since the printer does not recognize
the larger legal-size paper, you must send it the proper commands (escape
sequences) to print correctly on the page. These commands should precede
the data in the file to be printed.
The following command line contains instructions to print on legal-size
paper in manual feed mode. This example is set up to print a file on an 8 ½
in. x 14 in. sheet of paper in portrait mode using manual feed. Table 2–1
describes each escape sequence in the example.
<ESC>[7<SP>I<ESC>[99;2;2550;4200<SP>{<ESC>[8<SP>J<ESC>[99!v
Table 2–1: Legal-Size Coding Example
Escape Sequence
Name of Command
Description
<ESC>[7<SP>I
SSU (Size Select Unit)
Units can be pixels, deci-
points, or centipoints. This
example uses pixels.
<ESC>[99;2;2550;4200<SP>{
DECSSS (Set Sheet Size)
Defines manual feed input
and the width (2550 pix-
els = 8 ½ in.) and length
(4200 pixels = 14 in.) of
the paper.
<ESC>[8<SP>J
PFS (Page Format Select)
Selects portrait mode of
printing
and
sets
the
margins for the larger
size paper.
<ESC>[99!v
DECASFC
(Automatic Sheet Feeder
Control)
Selects the manual feed
mode of operation.
NOTE: Manual feed
mode can also be selected
from the FEEDER Menu,
or from the control panel
using
Manual Feed
.
NOTE:
If you are using full or dual paint mode, send the appropriate
DECMM command.
See Appendix A for additional programming information.
For detailed
information about sending commands from the host computer, consult
the Digital ANSI-Compliant Printing Protocol Level 3 Programming
2–16
Operator’s Guide
Summary of Contents for DEClaser 2100 plus
