232 Alphabetical list of commands
Disabled
•
Enabled
: PHY is enabled.
•
Disabled
: PHY is disabled.
Reason
•
Blank if
Elem Status
is
OK
.
•
Error count interrupts
: PHY disabled because of error-count interrupts.
•
Phy control
: PHY disabled by a SES control page as a result of action by a Storage
Controller or user.
•
Not ready
: PHY is enabled but not ready. Appears for SC-1 PHYs when the partner I/O
module is not installed. Appears for Drive, SC-1, or Ingress PHYs when a connection problem
exists such as a broken connector.
•
Drive removed
: PHY disabled because drive slot is empty.
•
Unused - disabled by default
: PHY is disabled by default because it is not used.
•
Excessive Phy changes
: PHY is disabled because of excessive PHY change counts.
Example
Show expander status for a single-enclosure system with an empty disk slot:
# show expander-status
Encl Ctlr Phy Type Status Elem Status Disabled
Reason
-------------------------------------------------------------------------------
1 A 0 Drive Enabled - Healthy OK Enabled
1 A 1 Drive Enabled - Degraded Non-critical Enabled
Not ready
...
1 A 23 Drive Disabled OK Disabled
Drive removed
1 A 0 SC-1 Enabled - Healthy OK Enabled
1 A 1 SC-1 Enabled - Healthy OK Enabled
1 A 0 SC-0 Enabled - Healthy OK Enabled
...
1 A 3 SC-0 Enabled - Healthy OK Enabled
1 A 0 Egress Enabled - Healthy OK Enabled
...
1 A 3 Egress Enabled - Healthy OK Enabled
-------------------------------------------------------------------------------
Encl Ctlr Phy Type Status Elem Status Disabled
Reason
-------------------------------------------------------------------------------
1 B 0 Drive Enabled - Healthy OK Enabled
1 B 1 Drive Enabled - Degraded Non-critical Enabled
Not ready
...
1 B 23 Drive Disabled OK Disabled
Drive removed
1 B 0 SC-1 Enabled - Healthy OK Enabled
1 B 1 SC-1 Enabled - Healthy OK Enabled
1 B 0 SC-0 Enabled - Healthy OK Enabled
...
1 B 0 Egress Enabled - Healthy OK Enabled
...
1 B 3 Egress Enabled - Healthy OK Enabled
-------------------------------------------------------------------------------
Success: Command completed successfully. (2012-01-18 15:02:13)
Summary of Contents for P2000 G3
