Implement settings
65
6
Implement settings
You want to use Section Control and Rate Control. Both functions are lo-
cation-dependent and require accurate information about the tractor
combination:
the type and source of the speed information,
the position of the GPS aerial and
the implement mounting type.
You make this information available with CCI.Config.
You have the following setting options:
Tractor
Specify a tractor name and set the distances and speed source
amongst other things.
See chapter 6.2, Tractor.
.
Implement
Specify an implement name and set the implement type, working
width and the mounting type.
Select the implement.
See chapter 6.3, Implement.
GPS
Set the position of the GPS aerial and the interface.
See chapter 6.4, GPS.
CCI.Convert
CCI.Convert receives sensor data via the serial interface in the for-
mat LH5000, ASD or TUVR and forwards it on to the implement
over ISOBUS.
See chapter 6.5, CCI.Convert.
Tacho
In Tacho
you can see the applied speed,
you can see if you are in the optimum working area and,
you have direct access to the tractor and implement settings.
See chapter 6.6, Tacho.
Summary of Contents for CCI 1200
