9 Appendix
9.1 Data image of the technology modules
XI/ON: XNE-GWBR-2ETH-MB
10/2011 MN05002008Z-EN
www.eaton.com
171
Table 80:
Process input
data / check-
back interface of
XNE-2CNT-
2PWM
Byte Bit
Value
Meaning
CNTx
0,2
STS_CNTx_GENERAL_EN
0
Function (CNTx) disabled
1
Function enabled
STS_CNTx_RUN
0
CNTx Counter not ready to count
1
CNTx Counter ready to count
STS_CNTx_SFKT_EN
0
Special function of Z disabled for CNTx
1
Special function of Z enabled for CNTx
STS_CNTx_LOGMSG
0
Curent status of MSG bits
1
Status of MSG bits are frozen
STS_CNTx_DIR
0
CNTx Counter counts down.
1
CNTx Counter counts up.
Ax, Bx, Zx
0
Digital input is LOW.
1
Digital input is HIGH.
1,3
MSG_CNTx_CMP0
0
No message active that reports that the
compare value CMP0 has been reached.
1
The counter CNTx reports that the compare
value CMP0 was reached.
MSG_CNTx_CMP1
0
No message active that reports that the
compare value CMP1 has been reached.
1
The counter CNTx reports that the compare
value CMP1 was reached.
MSG_CNTx_UFLW
0
No message active that reports that the lower
count limit has been reached.
1
The counter CNTx reports the lower count
limit was reached.
MSG_CNTx_OFLW
0
No message active that reports that the upper
count limit has been reached.
1
The counter CNTx reports the upper count
limit was reached.
MSG_CNTx_ND
0
No message active that reports a zero
crossing.
1
The counter CNTx reports a zero crossing.
