Chapter 8: Using the Command Line Interface
524
Power Control Operations
This section applies to outlet-switching capable models only.
Outlets on the PX3 device can be turned on or off or power cycled
through the CLI.
Besides, you can cancel the power-on process while the PX3 is powering
on ALL outlets.
You must perform this operation in the
administrator mode. See
Different CLI Modes and Prompts
(on page 368).
Turning On the Outlet(s)
This section applies to outlet-switching capable models only.
This command turns on one or multiple outlets.
#
power outlets <numbers> on
To quicken the operation, you can add the parameter "/y" to the end of
the command, which confirms the operation.
#
power outlets <numbers> on
/y
Variables:
<numbers> is one of the options:
all, an outlet number, a list or a
range of outlets.
Option
Description
all
Switches ON all outlets.
A specific outlet
number
Switches ON the specified outlet.
A comma-
separated list
of outlets
Switches ON multiple, inconsecutive or
consecutive outlets.
For example, to specify 7 outlets -- 2, 4, 9, 11, 12,
13 and 15, type
outlets 2,4,9,11-13,15
.
A range of
outlets with an
en dash in
between
Switches ON multiple, consecutive outlets.
For example, to specify 6 consecutive outlets -- 3,
4, 5, 6, 7, 8, type
outlets 3-8
.
Summary of Contents for PX3-1000 series
