Chapter 8: Using the Command Line Interface
425
Option
Description
full Full
duplex:
Data is transmitted in both directions
simultaneously.
Setting Wireless Parameters
You must configure wireless parameters, including Service Set Identifier
(SSID), authentication method, Pre-Shared Key (PSK), and Basic Service
Set Identifier (BSSID) after the wireless networking mode is enabled.
A wireless configuration command begins with
network wireless.
Note: If current networking mode is not wireless, the SSID, PSK and
BSSID values are not applied until the networking mode is changed to
"wireless." In addition, a message appears, indicating that the active
network interface is not wireless.
Setting the SSID
This command specifies the SSID string.
config:#
network wireless SSID <ssid>
Variables:
<ssid> is the name of the wireless access point, which consists of:
- Up to 32 ASCII characters
- No spaces
- ASCII codes 0x20 ~ 0x7E
Setting the Authentication Method
This command sets the wireless authentication method to either PSK or
Extensible Authentication Protocol (EAP).
config:#
network wireless authMethod <method>
Variables:
<method> is one of the authentication methods:
PSK or EAP.
Method
Description
PSK
The wireless authentication method is set to PSK.
Summary of Contents for PX3-1000 series
