T2700G-28TQ
JetStream 28-Port Gigabit Stackable L2+ Managed Switch CLI Guide
239
drop
—— When the number of the dynamic multicast groups that a port joins
has exceeded the max-group, the port will not join any new multicast group.
replace
—— When the number of the dynamic multicast groups that a port joins
has exceeded the max-group, the newly joined multicast group will replace an
existing multicast group with the lowest multicast group address.
Command Mode
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet/
interface ten-gigabitEthernet / interface range ten-gigabitEthernet)
Example
Specify the maximum numbers of groups that ports 1/0/2-5 can join as 10, and
configure the throttling action as replace:
T2700G-28TQ(config)#interface range gigabitEthernet
1/0/2-5
T2700G-28TQ(config-if-range)#ip igmp snooping max-groups
10
T2700G-28TQ(config-if-range)#ip igmp snooping max-groups action
replace
ip igmp snooping multi-vlan-config
Description
The
ip igmp snooping multi-vlan-config
command is used to create and
configure a Multicast VLAN. To delete the corresponding Multicast VLAN,
please use
no ip igmp snooping multi-vlan-config
command.
Syntax
ip igmp snooping multi-vlan-config
[
vlan-id
] {
rtime
router-time |
mtime
member-time |
ltime
leave-time |
rport interface
{
fastEthernet
port
|
gigabitEthernet
port
|
ten-gigabitEthernet
port
} }
no ip igmp snooping multi-vlan-config
Parameter
vlan-id
—— The ID of the VLAN desired to modify configuration, ranging from 2
to 4094.
router-time
—— Router Port Time. Within this time, if the switch does not
receive IGMP query message from the router port, it will consider this port is not
a router port any more. Router Port Time ranges from 60 to 600 in seconds. By
default, it is 300.