T2700G-28TQ
JetStream 28-Port Gigabit Stackable L2+ Managed Switch CLI Guide
347
Command Mode
Interface Configuration Mode
Example
Name the vrid 4 as vr4 on interface VLAN 3:
T2700G-28TQ(config)#interface vlan
3
T2700G-28TQ(config-if)#vrrp vrid
4
description
vr4
vrrp vrid priority
Description
This command is used to set the priority value for the virtual router configured
on a specified interface. To restore to the default priority, please use
no vrrp
vrid priority
command.
Syntax
vrrp vrid
vrid
priority
pri
no vrrp vrid
vrid
priority
Parameter
vrid
—— The virtual router ID.
pri
—— Priority, ranging from 1 to 254. By default, the priority value is 100.
Command Mode
Interface Configuration Mode
Example
Configure the priority for the interface VLAN 3 as 123 in vrid 4:
T2700G-28TQ(config)#interface vlan
3
T2700G-28TQ(config-if)#vrrp vrid
4
priority
123
vrrp vrid timer-advertise
Description
This command sets the frequency, in seconds, that an interface on the specified
virtual router sends a virtual router advertisement. To restore the advertisement
interval to default value for an interface, please use
no vrrp vrid
timer-advertise
command.