T2700G-28TQ
JetStream 28-Port Gigabit Stackable L2+ Managed Switch CLI Guide
139
Parameter
unit--id
——
Specify the unit-id of the switch in the stack.
vlan-
id
——
Specify the VLAN which the switch belongs to.
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Example
Display the total amount of MAC address table in all the units of the stack sorted
by VLAN:
T2700G-28TQ(config)#show mac address-table count
Display the total amount of MAC address table in unit 2 of the stack sorted by
VLAN:
T2700G-28TQ(config)#show mac address-table count unit
2
Display the total amount of MAC address table in VLAN 1 of unit 2 of the stack:
T2700G-28TQ(config)#show mac address-table count unit
2
vlan
1
Display the total amount of MAC address table in VLAN 2 of all the units of the
stack:
T2700G-28TQ(config)#show mac address-table count vlan
2
show mac address-table address
Description
The
show mac address-table address
command is used to display the
information of a specified MAC address.
Syntax
show mac address-table address
mac-addr
[
interface
{
fastEthernet
port
|
gigabitEthernet
port |
ten-gigabitEthernet
port
} ] [
vid
vlan-id
]
Parameter
mac-addr
—— The specified MAC address.
port
——
The Fast/Gigabit/ten-Gigabit Ethernet port number.
vlan-
id
——
Specify the VLAN which the entry belongs to.