S e n d c o m m e n t s t o n e x u s 3 k - d o c f e e d b a c k @ c i s c o . c o m
-SM-158
Cisco Nexus 3000 Series NX-OS System Management Command Reference
OL-29557-04
Chapter System Management Commands
ptp announce
ptp announce
To configure the interval between Precision Time Protocol (PTP) announce messages on an interface or
the number of PTP intervals before a timeout occurs on an interface, use the
ptp announce
command.
To remove the interval configuration for PTP messages, use the
no
form of this command.
ptp announce
{
interval
seconds
|
timeout
count
}
no ptp announce
{
interval
seconds
|
timeout
count
}
Syntax Description
Command Default
interval 1
timeout 3
Command Modes
Interface configuration mode
Command History
Usage Guidelines
Make sure that you have globally enabled PTP on the switch and configured the source IP address for
PTP communication.
This command does not require a license.
Examples
This example shows how to configure the interval between PTP announce messages on an interface:
switch#
configure terminal
switch(config)#
interface ethernet 1/5
switch(config-if)#
ptp announce interval 1
switch(config-if)#
This example shows how to remove the interval configuration for PTP messages from an interface:
switch#
configure terminal
switch(config)#
interface ethernet 1/5
switch(config-if)#
no ptp announce interval 1
switch(config-if)#
interval
Specifies the interval between Precision Time Protocol (PTP) announce
messages on an interface.
seconds
Log seconds. The range is from 0 to 4.
timeout
Specifies the number of PTP intervals before a timeout occurs on an
interface.
count
Timeout count. The range is from 2 to 10. Beginning in Release 7.0(3)|2(1),
the value is 2 to 4.
Release
Modification
7.0(3)|2(1)
The count changed to 2 to 4.
5.0(3)U2(2)
This command was introduced.