S e n d c o m m e n t s t o n e x u s 3 k - d o c f e e d b a c k @ c i s c o . c o m
-SM-160
Cisco Nexus 3000 Series NX-OS System Management Command Reference
OL-29557-04
Chapter System Management Commands
ptp delay-request minimum interval
ptp delay-request minimum interval
To configure the minimum interval allowed between Precision Time Protocol (PTP) delay-request
messages when the port is in the master state, use the
ptp delay-request minimum interval
command.
To remove the minimum interval configuration for PTP delay-request messages, use the
no
form of this
command.
ptp delay-request minimum interval
seconds
no ptp delay-request minimum interval
seconds
Syntax Description
Command Default
None
Command Modes
Interface configuration mode
Command History
Usage Guidelines
Make sure that you have globally enabled PTP on the switch and configured the source IP address for
PTP communication.
This command does not require a license.
Examples
This example shows how to configure the minimum interval allowed between PTP delay-request
messages:
switch#
configure terminal
switch(config)#
interface ethernet 1/5
switch(config-if)#
ptp delay-request minimum interval 3
switch(config-if)#
This example shows how to remove the minimum interval configuration for PTP delay-request
messages:
switch#
configure terminal
switch(config)#
interface ethernet 1/5
switch(config-if)#
no ptp delay-request minimum interval 3
switch(config-if)#
Related Commands
seconds
Log seconds. The range is from -1 to 6.
Release
Modification
5.0(3)U2(2)
This command was introduced.
Command
Description
feature ptp
Enables or disables PTP on the device.
ptp
Enables or disables PTP on an interface.