DX-1S Digital PABX - Programming Manual
5-9
5.1.35 PROGRAMMING ITEM 34 : APPLY CALL RESTRICTION TO SPEED DIALING
If this item is enabled, the extension will be prohibited to use the Speed Dialing Number which is
restricted by his/her Extension Dialing Class.
Command
3 * 34 * Value <Enter>
where Value = 1 to enable the feature; 0 to disable the feature
Default Value
Default = 1 (enable)
Related Topic
1.
Programming Item 83 - Extension Dialing Class - Day/Check-in
2.
Programming Item 84 - Extension Dialing Class - Night/Check-in
5.1.36 PROGRAMMING ITEM 35: SMDR CALL SELECTION
This item determines what types of call should be printed in SMDR.
Command
3 * 35 * Value <Enter>
where Value = 0 : No SMDR output
Value = 1 : Print IDD calls only
Value = 2 : Print IDD & LDD calls only
Value = 3 : Print all outgoing calls only
Value = 4 : Print all outgoing calls and incoming calls
Value = 5 : Print all outgoing calls, incoming calls and intercom calls
Default Value
Default = 3 : Print all outgoing calls only
5.1.37 PROGRAMMING ITEM 36 : SMDR START TIME
If the trunk line from public exchange do not give line reversal signal, the system cannot identify whether
the call is connected or disconnected. The system will start timing the call after the last digit was keyed
and stop timing when the extension hanged up. This feature may also be used to delay the SMDR Start
Time after the last digit timeout.
SMDR Call Duration = (Duration between last outgoing digit is keyed to call disconnected)
- (SMDR Start Time) - (Trunk Dialing Timeout B)
Command
3 * 36 * Value <Enter>
where Value = 1 ~ 255 (seconds)
Condition
1.
When Line Reversal Detection feature is in use, SMDR Start Time will not be used in measure call
duration. The SMDR Call Duration = (Duration between line reversal received to call disconnected).
Default Value
Default = 5 (seconds)
Related Topic
1.
Programming Item 62 - Line Reversal Detection.
