DX-1S Digital PABX - Programming Manual
5-15
5.1.54 PROGRAMMING ITEM 53 : ALLOW DISA TRUNK ACCESS
This item is to determine if the caller of an incoming call is allowed to access the trunk of the system to
make outgoing calls in DISA mode.
Command
3 * 53 * Value <Enter>
where Value = 1 to enable the feature
Value = 0 to disable the feature
Default Value
Default = 0 (disable)
Example
3 * 53 * 1 <Enter> - the caller of an incoming call is allowed to access the trunk to make outgoing calls
in DISA mode.
Related Topic
1.
Programming Item 54 - Allow DISA Speed Dialing Access
5.1.55 PROGRAMMING ITEM 54 : ALLOW DISA SPEED DIALING ACCESS
This item is to determine if the caller of an incoming call is allowed to access Speed Dialing of the system
to make outgoing calls in DISA mode.
Command
3 * 54 * Value <Enter>
where Value = 1 to enable the feature
Value = 0 to disable the feature
Default Value
Default = 0 (disable)
Example
3 * 54 * 1 <Enter> - the caller of an incoming call is allowed to access Speed Dialing to make outgoing
calls in DISA mode.
Related Topic
1.
Programming Item 53 - Allow DISA Trunk Access
5.1.56 PROGRAMMING ITEM 55 : TRUNK TO TRUNK TRANSFER STATUS
This item is to determined if the Trunk To Trunk Transfer feature is allowed to use in the system.
The Trunk To Trunk Transfer feature can be used in following condition :
•
Programming Item 55 : Trunk To Trunk Transfer is enabled and Programming Item 62 : Line
Reversal Detection is enabled and Programming Item 69 : Remote Disconnect is programmed to 1.
•
Programming Item 55 : Trunk To Trunk Transfer is enabled and Programming Item 69 : Remote
Disconnect is programmed to 2.
Command
3 * 55 * Value <Enter>
where Value = 1 to enable the feature
Value = 0 to disable the feature
Default Value
Default = 0 (disable)
Example
3 * 55 * 1 <Enter> - to enable the trunk to trunk call feature.
Related Topic
1.
Programming Item 51 - Trunk To Trunk Call Timeout
2.
Programming Item 62 - Line Reversal Detection
3.
Programming Item 69 - Remote Disconnect