DX-1S Digital PABX - Programming Manual
5-47
5.7.28 PROGRAMMING ITEM 127 : E&M PRE-DIGIT PAUSE
This programming item is to set the E&M Pre-Digit Pause Time.
Command
3 * 127 * Value <Enter>
where Value = 1 ~ 100 equivalent to 0.1 second to 10 seconds
Default Value
Value = 6 ( 0.6 second )
5.7.29 PROGRAMMING ITEM 128 : E&M WINK TIME
This programming item is to set the E&M Wink Time.
Command
3 * 128 * Value <Enter>
where Value = 0 : 150 ms Wink Time
Value = 1 : 200 ms Wink Time
Value = 2 : 250 ms Wink Time
Value = 3 : 300 ms Wink Time
Default Value
Value = 2 (250 ms)
5.7.30 PROGRAMMING ITEM 129 : E&M SIGNALING TIMEOUT
This programming item is to set the E&M Signaling Timeout.
Command
3 * 128 * Value <Enter>
where Value = 0 ~ 100 ( time in seconds )
Default Value
Value = 60 (60 seconds)
5.7.31 PROGRAMMING ITEM 130 : PCM GAIN
This programming item is to set the PCM Gain. If the value is greater, the gain level will be higher.
Command
3 * 130 * Value <Enter>
where Value = 1 ~ 255 : Gain (relative)
Note : For every unit offset from the default value, 0.1 dB is changed.
Default Value
Value = 208 (-3.5dB)
5.7.32 PROGRAMMING ITEM 131 : MFC TRANSCEIVER SERVICE STATUS
This is to program the service status of MFC Transceiver in PCM card.
Command
3 * 131 * Index1 * Value <Enter> or
3 * 131 * Index1 * Value * Index2 <Enter>
where Index1 = 0 ~ 7 MFC Channel Number
Index2 = 0 ~ 7 MFC Channel Number <Optional>
Value = 1 : enable, 0 : disable
Default Value
Value = 1
