Command Manual – Port Correlation Configuration
H3C S7500E Series Ethernet Switches
Chapter 1 Ethernet Port Configuration
Commands
1-27
Parameters
all
: Disables the storm constrain function for all types of packets (that is, multicast
packets, and broadcast packets).
broadcast
: Enables/Disables the storm constrain function for broadcast packets.
multicast
: Enables/Disables the storm constrain function for multicast packets.
pps
: Specifies the thresholds to be configured are measured in pps.
max-pps-values
: Upper threshold to be set, in pps, representing packets per second.
The value range of max-pps varies with port types.
min-pps-values
: Lower threshold to be set, in the range 1 to
max-pps-values
(in pps).
Description
Use the
storm-constrain
command to enable the storm constrain function for specific
type of packets and set the upper and lower thresholds.
Use the
undo storm-constrain
command to disable the storm constrain function for
specific type of packets.
By default, the storm constrain function is not enabled.
Note:
z
Do not use the
storm-constrain
command along with the
multicast-suppression
command, or the
broadcast-suppression
command. Otherwise, traffics may be
suppressed in an unpredictable way.
z
An upper threshold cannot be less than the corresponding lower threshold. Besides,
do not configure the two thresholds to the same value.
Examples
# Enable the storm constrain function for broadcast packets on Ethernet 2/0/1, setting
the upper and lower threshold to 200 pps and 150 pps.
<Sysname> system-view
[Sysname] interface ethernet 2/0/1
[Sysname-Ethernet2/0/1] storm-constrain broadcast pps 200 150
1.1.27 storm-constrain control
Syntax
storm-constrain control
{
block
|
shutdown
}
undo storm-constrain control