Chapter 6 Instruction and Flag List
XBC E-Type Main Unit
6-1
Ver. 1
Chapter 6 Instruction and Flag List
6.1 Classifications of Instructions
Classification
Instructions
Details
Remarks
Basic
Instructions
Contact Point
LOAD, AND, OR related Instructions
Unite
AND LOAD, OR LOAD, MPUSH, MLOAD, MPOP
Reverse
NOT
Master Control
MCS, MCSCLR
Output
OUT, SET, RST, 1 Scan Output Instruction, Output Reverse
Instruction (FF)
Sequence/Last-
input Preferred
Step Control Instruction ( SET Sxx.xx, OUT Sxx.xx )
End
END
Non-Process
NOP
Timer
TON, TOFF, TMR, TMON, TRTG
Counter
CTD, CTU, CTUD, CTR
Application
Instructions
Data Transfer
Transfers specified Data, Group, String
4/8/64 Bits
available
Conversion
Converts BIN/BCD of specified Data & Group
4/8 Bits available
Data Type
Conversion
Converts Integer/Real Number
Output Terminal
Compare
Saves compared results in special relay
Compare to
Unsigned
Input Terminal
Compare
Saves compared results in BR. Compares Real Number, String &
Group. Compares 3 Operands
Compare to
Signed
Increase/Decrease
Increases or decreases specified data 1 by 1
4/8 Bits available
Rotate
Rotates specified data to the left and right,
including Carry
4/8 Bits available
Move
Moves specified data to the left and right, word by word, bit by bit
4/8 Bits available
Exchange
Exchanges between devices, higher & lower byte, group data
BIN Operation
Addition, Subtraction, Multiplication & Division for Integer/
Real Number, Addition for String, Addition & Subtraction for Group
BCD Operation
Addition, Subtraction, Multiplication, Division.
Logic Operation
Logic Multiplication, Logic Addition, Exclusive OR, Exclusive NOR,
Group Operation
System
Error Display, WDT Initialize, Output Control, Operation Stop, etc.
Data Process
Encode, Decode, Data Disconnect/Connect, Search, Align, Max.,
Min., Total, Average, etc.
Data Table Process Data Input/Output of Data Table
String Process
String related Convert, Comment Read, String Extract, ASCII
Convert, HEX Convert, String Search, etc.
Special Function
Trigonometric Function, Exponential/Log Function, Angle/ Radian
Convert, etc.
Data Control
Max/Min Limit Control, Dead-zone
Control, Zone Control
Time related
Date Time Data Read/Write, Time Data Adjust & Convert
Diverge
JMP, CALL
Loop
FOR/NEXT/BREAK
Flag related
Carry Flag Set/Reset, Error Flag Clear
Special/Comm
related
Data Read/Write by BUSCON Direct Access
Interrupt related
Interrupt Enable/Disable
Signal Reverse
Reverse Integer/Real Signals, Absolute Value Operation
File related
Block Read/Write/Compare/Convert, Flash data Transmission
Summary of Contents for XBC-DN10E
Page 1: ......
Page 10: ...Table of Contents Table of Contents 6 10 10 CLEAR ALL PLC 29...