Field
Description
The function is enabled with
;
.
The function is disabled by default.
Class ID
Only for High Priority Class not active.
Choose a number which assigns the data packets to a class.
Note
The class ID is a label to assign data packets to specific
classes. (The class ID defines the priority.)
Possible values are whole numbers between
and
)
.
Set DSCP/TOS value
(Layer 3)
Here you can set or change the DSCP/TOS value of the IP data
packets, based on the class (Class ID) that has been defined.
Possible values:
•
5$-$6
(default value): The DSCP/TOS value of the IP
data packets remains unchanged.
•
! 5 9$< @:
: Differentiated Services Code Point
according to RFC 3260 is used to signal the priority of IP
packets (indicated in binary format).
•
! 5 !3 @:
: Differentiated Services Code Point
according to RFC 3260 is used to signal the priority of IP
packets (indicated in decimal format).
•
! 5 (#3 @:
: Differentiated Services Code
Point according to RFC 3260 is used to signal the priority of
IP packets (indicated in hexadecimal format).
•
' 9$< @:
: The TOS value is specified in binary
format, e.g. 00111111.
•
' !3 @:
: The TOS value is specified in decimal
format, e.g. 63.
•
' (#3 @:
: The TOS value is specified in
hexadecimal format, e.g. 3F.
Set COS value
(802.1p/Layer 2)
Here you can set/change the service class (Layer 2 priority) in
the VLAN Ethernet header of the IP packets, based on the class
(Class ID) that has been defined.
20 Networking
bintec elmeg GmbH
392
elmeg hybird 120 / hybird 130
