118
LTP-8X(switch)(config)# exit
Step 16.
Set up IGMP Proxy in the switch view for VLAN 98, enable the IGMP Proxy mode globally,
and set the range of allowed IGMP groups. Also, enable IGMP Snooping globally:
LTP-8X# switch
LTP-8X(switch)# configure
LTP-8X(switch)(config)# vlan 98
LTP-8X(switch)(config-vlan-range)# ip igmp snooping querier enable
LTP-8X(switch)(config)# ip igmp snooping
LTP-8X(switch)(config)# ip igmp proxy report range 232.1.0.1 232.1.0.100 from all to 98
LTP-8X(switch)(config)# ip igmp proxy report enable
LTP-8X(switch)(config)# commit
LTP-8X(switch)(config)# exit
Bridged Mode
Configure the Internet (PPPoE), IPTV unicast, and management services via the TR-069 protocol. Set
the subscriber VLAN ID to 200. Configure transmission of tagged traffic to LAN port 1. To do this, set the
U-VLAN ID to 10. Traffic to port 2 will be transmitted untagged. Multicast traffic will be transmitted to
VLAN 98, management will be performed via VLAN 9.
Fig. 28.4 – Bridged Service Abstract Representation for Model 1
Step 1.
Create an Internet cross-connect profile to configure PPPoE in the bridge. Configure the
bridged service specifying the bridge group the ONT port will be connected to (in this case, it is equal to
10 for the first service), define a U-VLAN for transmission of tagged traffic to the port:
LTP-8X(config)# profile cross-connect Internet
LTP-8X(config-cross-connect)("Internet")# bridge
LTP-8X(config-cross-connect)("Internet")# bridge group 10
LTP-8X(config-cross-connect)("Internet")# user vid 10
Step 2.
Check the changes made.
LTP-8X(config-cross-connect)("Internet")# do show profile cross-connect Internet
Name: 'Internet'
Description: 'ONT Profile Cross Connect 1'
Model: ont
Bridge group: 10
Tag mode: single-tagged
Summary of Contents for LTP-4X
