79
TTL = min(65535,LLDP-Timer * LLDP-HoldMultiplier)
Step 5.
Specify time for LLDP reinitialization:
LTP-8X(switch)(config)# lldp reinit 3
Step 6.
Specify, how often the device will send LLDP information update:
LTP-8X(switch)(config)# lldp timer 60
Step 7.
Set the value of a delay between further LLDP packet transmissions initiated by the changes of
the values or statuses in MIB LLDP local bases:
LTP-8X(switch)(config)# lldp tx-delay 3
It is recommended that the value of delay is less than 0.25* LLDP-Timer.
Step 8.
Set the LLDP packet processing mode:
LLDP packet processing mode:
–
filtering – indicates that LLDP packets are filtered if LLDP is enabled on the switch;
–
flooding – indicates that LLDP packets are transmitted if LLDP is enabled on the switch.
LTP-8X(switch)(config)# lldp lldpdu flooding
Step 9.
Apply configuration by the
commit
command.
LTP-8X(switch)(config)# commit
Summary of Contents for LTP-4X
