Chapter 4: Using the Command Line Interface
TR0190 Rev. B1
25
4.5.5
‘use’ command
Syntax
use <interface>
where <interface> is one of the EL-500’s interfaces. A complete list of
interfaces is available with the ‘show’ command.
Description
Selects an interface to use. By selecting an interface you can view and
modify the parameters associated with the interface.
Example
use wlan1
will select the wlan1 virtual AP interface and change the CLI prompt to
wlan1>
to reflect the interface selection.
4.5.6
‘set’ command
Syntax
set <parameter>=<value>
where <parameter> is the parameter being set and <value> is the value it
is being set to.
Description
Sets a configuration parameter. Note that is only possible to set the
parameters for the currently selected interface. If the value of the
parameter contains spaces, the value must be surrounded by double
quotes (“ “).
If a valid 'set' command is entered, it will output its result and any effects on
other parameters. If changes are made to attributes of other interfaces as a
result of changing the parameter, these attributes are preceded by a '/' to
signify that they are in another interface.
Changing certain parameters will require the EL-500 to be rebooted.
Example
With the ‘sys’ interface selected
set id.node=2
will set the node ID to 2
Summary of Contents for EL-500
Page 20: ...Chapter 3 Using the Web Interface TR0190 Rev B1 20 Figure 8 Rebooting the EL 500...
Page 68: ...Chapter 11 Ethernet Interface Configuration TR0190 Rev B1 68 Figure 38 Wired DHCP settings...
Page 108: ...Chapter 16 Controlling Access to the ER 1000 TR0190 Rev B1 108 Figure 50 VAP ACL configuration...
