Chapter 9: System Settings
TR0190 Rev. B1
51
9.5
NetBIOS Server
The NetBIOS server parameter is used to define a NetBIOS server’s IP address that is
provided to client devices when configured by the EL-500’s local DHCP server.
The NetBIOS settings are not used when operating in bridge mode.
CLI
The NetBIOS server is set with the ‘netbios.servers’ parameter in the ‘sys’ interface. To specify
multiple NetBIOS servers, list them as a space-delimited string enclosed by quotes as shown
in the example below
>
use sys
sys>
set netbios.servers =”10.6.0.5 192.168.6.5”
Web GUI
A primary and secondary NetBIOS server can be set via the web interface using the “DNS” tab
on the “System Parameters” page (see Figure 26).
9.6
SNMP
The EL-500 supports SNMP.
The read-only and read-write passwords and the port that SNMP uses can be configured. A
contact person and device location can also be specified as part of the SNMP configuration.
CLI
The SNMP read-only and read/write passwords are set with the ‘snmp.community.ro’ and
‘snmp.community.rw’ parameters in the ‘sys’ interface. The example below shows how to set
these parameters.
>
use sys
sys>
set snmp.community.ro=”read-only_password”
sys>
set snmp.community.rw=”read-write_password”
The SNMP port is set with the ‘snmp.port’ parameter in the ‘sys’ interface as shown below. By
default this parameter is set to “161”.
>
use sys
sys>
set snmp.port=161
BRIDGE
Summary of Contents for EL-500
Page 20: ...Chapter 3 Using the Web Interface TR0190 Rev B1 20 Figure 8 Rebooting the EL 500...
Page 68: ...Chapter 11 Ethernet Interface Configuration TR0190 Rev B1 68 Figure 38 Wired DHCP settings...
Page 108: ...Chapter 16 Controlling Access to the ER 1000 TR0190 Rev B1 108 Figure 50 VAP ACL configuration...
