15
time Commands
Network elements on the Wireless Appliance can be synchronized to a universal clock in one of two
ways:
•
using the Wireless Appliance's own system time
•
using the Network Time Protocol
The commands described in this section are used to select and configure these options, and are located
in the time context of the CLI.
All CLI commands cache changes. For this reason, sometimes when you make a change in a particular
context, the change may not be visible immediately. If this happens, you must exit and re-enter the
context in order to ensure that the database is synchronized with the latest change.
After you run any of the
time
commands, run the
apply
command to implement the changes.
The following commands are available in the time context:
•
on page 224
•
•
•
•
on page 226
clock
Use the
clock
command to set the system time.
The Network Time Protocol must be disabled before this command can be used. For more information,
see
After you run the
clock
command, run the apply command to implement the changes.
clock hh:mm
Parameters
hh
Specifies the current hour (in 24 hour clock format)
mm
Specifies the current minute
SCALANCE WLC711 CLI Reference Guide
224
Summary of Contents for scalance WLC711
Page 1: ...SCALANCE WLC711 CLI Reference Guide Release V9 21 14 C79000 G8976 C261 07 Published July 2015 ...
Page 21: ...dns 2 192 1 2 3 dns 3 192 1 3 3 Common Commands show SCALANCE WLC711 CLI Reference Guide 21 ...
Page 376: ...Example topology Commands vlanid SCALANCE WLC711 CLI Reference Guide 376 ...
